Paper Feed Unit Removal - Lexmark C925 Service Manual

5041-030

Paper feed unit removal

Note: Remove the main tray paper guide and the multi-purpose feed tray paper guide. These will be used on
the new paper feed unit. See
paper guide removal" on page
1.
Remove the HVPS. See
2.
Remove the complete duplex unit. See
3.
Remove the right link arm (A).
4.
Disconnect the registration clutch harness from connector CN20 on the printhead controller board.
5.
Disconnect the pick roll, separator roll, and feed roll clutch cables from connector CN8 on the MDCONT
(Engine) board.
6.
Disconnect the paper feed unit motor harness from connect or CN16 on the MDCONT (Engine) board.
7.
Disconnect the paperfeed units sensors cable from CN12 on the engine board.
8.
Remove the five screws (B) securing the paper feed unit to the printer frame.
Note: See "Paperfeed unit component removals" on page 4-94
sub-components.
4-58
Service Manual
"Main tray paper guide removal" on page 4-95
4-97.
"HVPS removal" on page
"Duplex removal" on page
and "Multi-purpose feed tray
4-87.
4-53.
for instructions to remove the paperfeed unit
Previous
Next
Go Back