Lexmark C925 Service Manual page 85

Error code Action
37 Insufficient memory
for Flash Memory
Defragment operation
37 Insufficient memory,
Some Held Jobs Were
Not Restored
37 Insufficient memory,
Some Held Jobs Will
Not Be Restored
37 Insufficient Defrag There is insufficient memory to perform the Flash Memory Defragment operation. The user
Memory can:
38 Memory Full The following options are available:
39 Complex Page The page is too complex to print. Options are:
50 PPDS Font Error
51 Defective Flash
52 Flash Full
53 Unformatted Flash
• Select Continue to stop the defragment operation and continue printing.
• Delete fonts, macros, and other data in printer memory.
• Install additional printer memory.
• If this does not fix the problem, replace the RIP board. See
page 4-46.
• The printer deleted some held jobs in order to process current jobs.
• Select Continue to clear the message.
• If this does not fix the problem, replace the RIP board. See
page 4-46.
• The printer was unable to restore some or all of the confidential or held jobs on the hard
disk.
• Select Continue to clear the message.
• If this message occurs again, replace the hard drive.
• If this does not fix the problem, replace the RIP board. See
page 4-46.
• Delete font, macros, and other data in memory.
• Install additional printer memory.
• Select Continue to clear the message and continue printing. The job may not print
correctly.
• Cancel the current job.
• Install additional printer memory.
• If this does not fix the problem, replace the RIP board. See
page 4-46.
• Select Continue to continue. The job may not print correctly.
• Cancel the job.
• Select Continue to clear the message and continue printing. The job may not print
correctly.
• Cancel the current job.
• If this does not fix the problem, replace the RIP board. See
page 4-46.
• Select Continue to clear the message and continue printing.
• Install different flash memory before downloading any resources to flash.
• If this does not fix the problem, replace the RIP board. See
page 4-46.
• Select Continue to clear the message and continue printing.
Note: Downloaded fonts and macros not previously stored in flash memory are deleted.
• Delete fonts, macros, and other data stored in flash memory.
• Install a larger capacity flash memory card.
• If this does not fix the problem, replace the RIP board. See
page 4-46.
• Select Continue to clear the message and continue printing.
• Format the flash memory before storing any resources on it. If the error message
remains, replace the flash memory.
• If this does not fix the problem, replace the RIP board. See
page 4-46.
5041-030
"RIP board removal" on
"RIP board removal" on
"RIP board removal" on
"RIP board removal" on
"RIP board removal" on
"RIP board removal" on
"RIP board removal" on
"RIP board removal" on
2-53
Diagnostic information
Previous
Next
Go Back