Printing A Configuration Sheet; Attaching The 4247 Printer To Your Computer - Compuprint Z03 User Manual

Printing a configuration sheet

You have just completed a setup and checkout of the printer.
We recommend that you now print your printer configuration defaults. Save this
printout for future reference. You can create a printout of the printer configuration
by following these steps:
1. Ensure that the printer is OFFLINE. Press STOP to make the printer NOT
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays:
3. Press ENTER or START to print this test. See "Print Custom Sets" in the 4247
4. To exit Operator Print Tests, press RETURN to make the printer NOT

Attaching the 4247 Printer to your Computer

This printer can be connected to your host computer with the interfaces available
on the Controller Board you have found in the printer box and installed on the
rear of the printer.
There are three types of Controller Boards:
1. Controller Board with a bidirectional IEEE1284 parallel interface, Serial
2. Controller Board with a bidirectional IEEE1284 parallel interface and ASCII
3. Controller Board with a bidirectional IEEE1284 parallel interface and
1. Turn off the printer power.
2. Unplug the printer power cord.
3. Insert the host computer cable(s) into the back of the printer as shown below:
28
Quick Setup Guide
READY.
OPERATOR PRINT TESTS
Print Custom Sets
Model Z03 Printer: User's Guide for more information about this printout.
READY or CANCEL PRINT to make the printer READY.
RS232/C 9-pin interface and USB 2.0 interface.
Ethernet 10/100 BaseT LAN interface.
ASCII-IPDS Ethernet 10/100 BaseT LAN interface.
DANGER
Switch off printer power and unplug the printer power cord before
connecting or disconnecting a communication port, a teleport, or other
attachment connector.