Compuprint Z03 User Manual page 45

Display Message
050 MACHINE CHECK X Y Z
SEE USER'S GUIDE
051 MACHINE CHECK X Y Z
SEE USER'S GUIDE
052 MACHINE CHECK X Y Z
SEE USER'S GUIDE
053 MACHINE CHECK X Y Z
SEE USER'S GUIDE
054 MACHINE CHECK
SEE USER'S GUIDE
055 MACHINE CHECK
SEE USER'S GUIDE
056 MACHINE CHECK
SEE USER'S GUIDE
An unrecoverable error has occurred.
Record the error information X, Y, Z.
059 CANCEL PRINT ACTIVE
This an informational message. The
printer displays this message after you
press CANCEL PRINT.
068 DATA CLEARED
PRESS STOP THEN START
070 PRINTER BOARD CHANGE
VERIFY MENU SETTINGS
Configuration and custom sets values
may have been lost when the printer
board was modified.
088 INVALID PAPER SOURCE
USE FRONT OR CHANGE MENU
Incorrect Power On Paper Source selected
in configuration. Change the configuration
to an available paper source.
089 RIBBON JAM
CHECK RIBBON
091 FANFOLD PARK
TEAR OUTPUT PRESS PARK
092 FANFOLD EJECT
TEAR INPUT PRESS EJECT
Recovery Action
1. Turn off the printer.
2. Wait 10 seconds, then turn on the printer.
3. If the printer displays this status code again, call for service.
1. Press START to cancel the current print job or press CANCEL
PRINT again (before pressing START) to return the printer to
READY. (The print job will not be cancelled.)
1. Press STOP.
2. Press START.
1. Press STOP.
2. Press MENU.
3. Verify the configuration values and custom sets. (See "Checking and
changing configuration parameter values" and "Custom sets" in the
User's Guide.)
4. Press START or Return to exit the menu. If the printer displays this
status code again, call for service..
1. Press STOP.
2. See "Configuring the Printer" in the User's Guide.
1. Turn off the printer.
2. Remove the ribbon cartridge.
3. Turn the ribbon advance knob to be sure that the ribbon is
advancing correctly. If the ribbon does not advance correctly, replace
the ribbon cartridge.
4. Reinstall the ribbon (see "Installing the ribbon cartridge" on page
12).
5. Turn on the printer.
6. If the printer this status code again, call for service.
1. Tear off the forms at the perforation before entry into the printer.
2. Press LOAD/EJECT.
1. Tear off the forms at the perforation.
2. Press PARK/PATH.
Setting up the 4247 Model Z03 Printer
33