Esc [ K Sets Initial Conditions. (Ibm 2391 Only) - Compuprint MDP 30FB Programmer's Manual

ESC [ K
Sets initial conditions. (IBM 2391 only)
ASCII Code ESC [ K n
Hexadecimal Value 1B 5B 4B n
27 91 75 n
Decimal Value
This command causes the printer to reset to its initial status:
n and n The n and n
1 2 1
normally, n
init The init parameter specifies to which condition the printer should initialize,
normally init = 0,1,4,5,254,255:
0 Initializes printer to user-default settings. The download font remains
unchanged. If parameters are specified, they will overwrite the default
settings. If the emulation mode is changed, the download font will be
initialized. This command will only copy data from the selected macro, add
parameter changes, if any, and store in working RAM; the data stored in
the macro's non-volatile RAM will not be affected.
1 Initializes printer to user-default settings. The download font is initialized. If
parameters are specified, they will overwrite the default settings. This
command will only copy data from the selected macro, add parameter changes,
if any, and store in working RAM; the data stored in the macro's non-volatile
RAM will not be affected.
4 Initializes printer to factory settings. The download font remains unchanged. If
parameters are specified, they will overwrite the default settings. If the
emulation mode is changed, the download font will be initialized. This
command will only copy the default settings from ROM, add parameter
changes, if any, and store in working RAM; the data stored in the macro's non-
volatile RAM will not be affected.
n init id
1 2
n init id
1 2
n init id
1 2
parameters specify the number of bytes in the escape sequence
2
= 2 and n = always 0.
1 2
89