Sony Ipela PCS-XG55 Integration Manual page 12

Connecting a BRC-H700/Z700 as the 1st camera
A BRC-H700/Z700 is connected as the 1st camera as described below.
You can use the breakout cable as explained in "Connecting an EVI-HD1 as the 1st camera".
n
Confi gure the cameras so that a COMPONENT signal is output from their RGB/COMPONENT outputs.
When using a camera other than the PCSA-CXG80, do not set "RF Remote Control Reception" to "Cam-
era".
PCS-XG Series main unit rear panel
CAMERA S VIDEO IN RGB IN RGB OUT
EC-MIC(A7) MIC(A1/A3)
1 2 1(R) 2(L)
R L R L R
AUDIO 1 IN AUDIO OUT REC OUT
(PLUG IN POWER)
Breakout cable is separately required.
(For detail, contact your local Sony Sales
Office/Service Center.)
Breakout
cable
1 2 3 4 5 6 7 8 9
OFF ON
75
VISCA RS-422 DC IN 12V
IN VISCA RS-232C OUT EXT SYNC IN RGB/COMPONENT
* The S VIDEO IN, EC-MIC (A7) 1/2, AUDIO 1 IN, EXT 1/2, and
The 1 connector on the PCS-XG80 main unit corresponds to the
1-8
*
HDMI OUT ISDN UNIT AUX CONTROL
L
DC 19.5V
1-EXT-2 1 2
BRC-H700
1 2 3
IR SELECT
OFF ON
DATA MIX
PCS-XG Series main unit rear panel
CAMERA S VIDEO IN RGB IN RGB OUT
EC-MIC(A7) MIC(A1/A3)
1 2 1(R) 2(L)
R L R L R L
AUDIO 1 IN AUDIO OUT REC OUT
(PLUG IN POWER)
Breakout
cable
1 2 3 4 5 6 7 8 9 IR SELECT
OFF ON
1 2 3
DATA MIX
VISCA RS-422 OFF ON
75
RGB/COMPONENT
IN VISCA RS-232C OUT EXT SYNC IN VIDEO S VIDEO
2 connectors are not available on the PCS-XG55 main unit.
connector on the PCS-XG55 main unit.
*
HDMI OUT ISDN UNIT AUX CONTROL
DC 19.5V
1-EXT-2 1 2
BRC-Z700
DC IN 12V
PCS-XG80