Getting the system log via telnet/SSH
To get the system log by telnet/SSH, input "pcslog" as the login name and password.
The system log that is collected during operation will be displayed.
3-6-3. Operation Log
Operation log is a record of operation made by remote commander, external command, and cgi command
(Web interface).
The example of Operation Log is as shown below.
Operation log
2008-06-02 12:43:55.802|info |1095.1095|remocon
2008-06-02 12:43:55.971|info |1086.1086|ms_checker
2008-06-02 12:43:56.087|info |1095.1095|remocon
2008-06-02 12:43:56.504|info |1095.1095|remocon
2008-06-02 12:43:56.739|info |1095.1095|remocon
2008-06-02 12:43:56.783|info |1095.1095|remocon
2008-06-02 12:43:57.011|info |1095.1095|remocon
2008-06-02 12:43:57.315|info |1095.1095|remocon
2008-06-02 12:43:59.790|info |1095.1095|remocon
An operation log is got via the Service Menu or the web interface.
Getting the Operation Log via the Service Menu
Insert the Memory Stick on which the operation log is stored into the Memory Stick slot on the front panel
of the main unit. Then, start the Service Menu. Before starting the Service Menu, refer to "3-5. Descrip-
tion on Service Menu". Using "Save Operation Log" of "Save/Load" in the Service Menu,
/MSSONY/PRO/TVCONF/DEBUG/PCS_OP.txt is saved to the Memory Stick as the operation log.
Getting the Operation Log via the Web Interface
Before starting up the web interface, refer to steps 2 and 3 in "3-1-1. Firmware Update by Using WEB
Control", or refer to the operating instructions supplied with the PCS-XG Series models.
Open the web page and then select "Download" in the left column. Then, click "Download" to the right of
"Save Operation Log". Download of the operation log starts.
PCS-XG80
|@OP@ remkey[0x3A]
|@OP@ MS Insert
|@OP@ remkey[0x90]
|@OP@ remkey[0x77]
|@OP@ remkey[0x90]
|@OP@ remkey[0x77]
|@OP@ remkey[0x90]
|@OP@ remkey[0x6E]
|@OP@ remkey[0x7B]
3-25