Ipv6; Multipoint Connection (Example Of Connection); (Main Terminal: Pcs-Xg80/Xg80S Only) - Sony Ipela PCS-XG55 Integration Manual

1-2-5. IPv6

This equipment supports the next-generation Internet Protocol version 6 (IPv6).
For details, refer to the operating instructions supplied with the PCS-XG Series models.
The functions of the system are restricted as follows when using Internet Protocol IPv6.
. SNMP Trap Destination
. NTP
. Shared Phone Book
. LAN2
n When "Line I/F → Use LAN2" is set to "On", you cannot use IPv6. When "Internet Protocol"
is set to "IPv6" under Administrator 7, "Use LAN2" is disabled (it cannot be set to "On".)

1-2-6. Multipoint Connection (Example of Connection)

(Main terminal: PCS-XG80/XG80S only)

To enable multipoint HD visual communication, you must install the optional PCSA-MCG80 HD MCU
software.
The PCSA-MCG80 HD MCU software allows you to establish multipoint communication over a LAN
and/or ISDN line. To install this optional software, refer to "3-2. Optional Software Installation".
n It cannot be installed in PCS-XG55/XG55S.
System confi guration via LAN for multipoint (IP connection)
This equipment allows you to establish multipoint HD visual communication with up to 10 sites over an
IP connection.
System confi guration
/
1
3
/
T
W
4
1 PCS-XG80S HD Visual
Communication System
2 PCSA-CXG80 HD Camera Unit
3 PCS-RF1 Remote Commander
4 TV monitor (not supplied)
5 PCS-A1 microphone
6 HD MCU software PCSA-MCG80 (Option)
1-30
. TOS
. Network Routing Check
. AMX Device Discovery
(Main terminal: PCS-XG80/XG80S only)
2
5
POWER/STANDBY
POWER/STANDBY
/
6
POWER/STANDBY
/
POWER/STANDBY
/
POWER/STANDBY
/
POWER/STANDBY
/
/
T
W
POWER/STANDBY
/
POWER/STANDBY
/
POWER/STANDBY
/
POWER/STANDBY
/
PCS-XG80