Sony Ipela PCS-XG55 Integration Manual page 27

Pairing Procedures
To pair the main unit or Camera with the Remote Commander again, follow the procedure below.
1. Turn on the main unit.
2. Under "General 1" of the General setup menu, set "RF
Remote Control Reception" to "System" or "Camera".
Refer to "RF Remote Control Reception" in 2-2-2
3. Within three minutes of turning the power on, position
the Remote Commander close to the main unit (within
20 cm (8 inches)), and then press the [RETURN] and
[TOOLS] buttons at the same time. The LED indica-
tor fl ashes rapidly.
4. Press the [ENTER] button on the Remote Command-
er.
If the LED indicator fl ashes more slowly, pairing
between the units has succeeded.
m
. If pairing fails, the LED indicator on the Remote Com-
mander will continue to fl ash rapidly. In this case, press
the [ENTER] button on the Remote Commander and try
the pairing operation again.
. To cancel pairing, press the I/ (power) switch on the
main unit.
. Once pairing is established between the units, it will not
be erased even when the batteries in the remote com-
mander are replaced.
. If you have lost the remote commander or if it no longer
works, obtain a replacement and perform pairing again.
. When the camera unit is to be paired with the Remote
Commander and then installed in a high location, per-
form the pairing before the installation.
PCS-XG80
PRESENTATION
LED
F1 F2
LAYOUT
VIDEO INPUT CAMERA
VOLUME
ENTER
[RETURN] button RETURN
BACK
CONNECT SPACE DISCONNECT
1 2
4 5
GHI
7 8
PQRS
TONE
0
ON/OFF
MIC
PCS-RF1
RF
I/O button
/
F3 F4
ZOOM
T
[ENTER] button
W
TOOLS [TOOLS] button
3
ABC DEF
6
JKL MNO
9
TUV WXYZ
DOT
1-23