Pen Tablet - Sony Ipela PCS-XG55 Integration Manual

Notes on monitor connections and settings
. When you wish to use an HDMI monitor, it must have a 1080i INPUT connection. A monitor without
the 1080i INPUT connection cannot display the menu.
. When you are using a 60-Hz monitor but the "Video1 → Frequency" is set to "50 Hz", the menu cannot
be displayed on the monitor and you cannot perform any menu operations.
In this case, access the Communication System by using a Web Browser and restore "Frequency" under
"Video:Basic" in the Setup Menu to "60 Hz".
Otherwise, restore the Frequency value to 60 Hz by connecting a serial cable to the AUX CONTROL port on the
rear of the Communication System and sending an external control command "setup save video frequency-60hz".
. When "Video1 → Monitor Output" is set to "HDMI + RGB", the picture from the camera or PC con-
nected to the RGB IN connector is displayed on the RGB monitor. If only the RGB monitor is connect-
ed, you cannot perform any menu operations.
In this case, also connect an HDMI monitor.
If an HDMI monitor is not available, access the Communication System by using a Web Browser and
set "Monitor Output" under "Video:Basic" in the Setup Menu to "RGB".
Otherwise, restore the "Monitor Output" to "RGB" by connecting a serial cable to the AUX CONTROL port on
the rear of the Communication System and sending an external control command "setup save video monout-rgb".

1-1-7. Pen Tablet

To use the function of Drawing and Pointing in communication, the pen tablet is needed.
To connect a Pen Tablet
1. Pen tablet is not a supplied accessories. So, prepare a pen tablet separately. About the pen tablet, refer
to the Notes as shown below.
2. Turn off the main unit.
3. Connect the pen tablet to the TABLET connector (PCS-XG80 main unit)/OPTION connector (PCS-
XG55 main unit) on the front panel of the main unit before power-on.
To TABLET connector (PCS-XG80 main unit)/
OPTION connector (PCS-XG55 main unit)
"Bamboo" (MTE450)
4. Press the I/ (power) switch to turn on the main unit.
m
. Supported TABLET models are Wacom "Bamboo" (MTE450) and "Bamboo" (CTH-460). "Bamboo"
(CTH-460) is usable in Ver.2.1 and later. When you use it, perform the upgrade to Ver.2.1 and later.
. The cable length which is supplied with "Bamboo" (MTE450) is 1.5 m (5 ft.). The USB cable length of
"Bamboo" (CTH-460) is 1.5 m (5 ft.).
. If you use another longer cable except the attached one, use the USB Hub, or extend the USB cable,
perform the verifi cation before use.
PCS-XG80
1.5 m (5 ft.) supplied cable with
"Bamboo" (MTE-450) or
cable connected with
"Bamboo" (CTH-460)
"Bamboo" (CTH-460)
1-21