SECTION 7—ARMS
Adjusting Non-Locking Cantilever Arm Height
NOTE: For this procedure, refer to FIGURE 7.9 on page 49.
1. Remove the locknut and washer from the lower hex bolt securing the cantilever arm
to the back cane.
2. Slide the cantilever arm assembly out of the back cane.
3. Reposition the cantilever arm assembly to the desired mounting hole.
4. Secure the cantilever arm to the wheelchair with a washer and locknut.
Adjusting Non-Locking Cantilever Arm Angle
NOTE: For this procedure, refer to FIGURE 7.10.
1. Loosen the mounting screw securing the cam to the cantilever arm.
2. Rotate the cam until the desired angle is achieved (Detail "B").
3. Tighten the mounting screw securing the cam to the cantilever arm.
Side View of Cam
Back Cane
Cam
Back
Cane
Cantilever Arm
Cantilever
Arm
DETAIL "B" - CAM POSITIONS
0° Arm Angle
4° Arm Angle
8° Arm Angle
12° Arm Angle
16° Arm Angle
Back
Back
Back
Back
Back
Cane
Cane
Cane
Cane
Cane
Cam
Cam
Cam
Cam
Cam
NOTE: All arm angles are relative to the back cane.
FIGURE 7.10 Adjusting Non-Locking Cantilever Arm Angle
®
™
50
Solara
/Spree GT
Part No 1125027