Table of Contents
Advertisement
SECTION 8—ADULT BACKS
Contoura Back
Back Cane
Washer
Locknuts
Socket
Screw*
Rear
Mounting
Bracket
Mounting
Screw
Socket
Screw*
Lower Front
Mounting Bracket
FIGURE 8.1 Removing/Installing the Contoura Back
Adjusting the Back Width
A new back pan is required when the back width is adjusted. Back width MUST be
adjusted with seat width. Refer to Adjusting the Seat Width on page 45.
Contoura Backs Only - Seat and back widths are restricted to 16, 18, 20, 22 or 24 inches.
Adjusting the Back Angle
Wheelchairs with TRRO Only - Adjusting the back angle from the factory setting
will void TRRO compliance. After adjusting the back angle, DO NOT transport an
occupied wheelchair in a motor vehicle of any kind. The wheelchair may only be
transported in a motor vehicle while unoccupied, and will be considered TRBKTS.
Adjustable ASBA Seat
Back Cane
Socket
Screws**
Washer
WARNING
38
Upper Front
Mounting Bracket
Mounting
Screw
Washer
Mounting Bracket
Washer
*NOTE: Remove these socket screws
when removing the back from the back
canes.
**NOTE: Remove these socket screws
when removing the hardware from the
back.
Socket
Screws*
Lower Front
Part No 1143238
Advertisement
Table of Contents
