Table of Contents
Advertisement
6. Press the
button repeatedly to scroll down to select Alternate Config,
as shown in Figure 3-23:
Unit Attn. Report:
*All:
Alternate Config:
*Standalone
Figure 3-23. Special Config Submenu, Scrolled
7. Press the
and then
Enter
Enter
again and after selection stops flashing. The screen shown in
Figure 3-24 appears:
Change Not Effective
Until Reboot
ENTER to Continue
Figure 3-24. Acknowledgment Screen
8. Press the
button. When the Special Configuration Submenu
Enter
reappears, turn the power switch off to recycle power.
NOTE: Expansion Unit installation remaps the cartridge slot numbering system as follows:
The 16-slots of the Expansion Unit become slot numbers 0-15. Slots 0-9 of the first Base
Module become slots 16-25, etc.
A Configuration Example - Setting the SCSI ID
1. Turn the system on, and wait until the Power-On Self Test terminates
and the default screen appears on the display. Figure 3-25 shows a
typical default screen. Yours may vary depending on the number of
modules in your system, as shown in the second line.
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.A01 File Name: d-ch3 Installation Last Saved On: 3/2/99 2:30 PM
button to change the line to 'Slave'. Press
Installation 3-37
Advertisement
Table of Contents
Troubleshooting
