Compaq TL891 - DLT Tape Library User Manual page 47

Scroll List - 'To' Line
There is another limitation on the 'To' list. If you have selected a drive on the
'From' screen, the 'To' list can include only slots. If you have selected a slot
on the 'From' screen, the 'To' list can contain only drives.
Let us assume that you want to load the cartridge that is in Slot 4 into any
available drive. Use the
shown n Figure 2-27 appears:
From:
Slot4
To:
*DLT0
Figure 2-27. Load/Unload 'From' Entry Screen
When you have scrolled to your desired source, press the Enter button to select it.
Notice that in Figure 2-28, two changes occur in the display.
The * reappears at the beginning of line 2, indicating that you have made a
selection.
The now moves to line 4, indicating that you may now select a destination.
From:
*Slot4
To:
*DLT0
Figure 2-28. Load/Unload 'To' Entry Screen
You can now simply press the
Note that there is no
are no additional choices because 1) you have selected a slot as the source, so
the destination must be a drive, and 2) DLT1 already has a cartridge in it, so it
cannot be a valid destination. Press the
response, the Confirmation Screen shown in Figure 2-29 appears:
From: Slot4 To:DLT0
ENTER To Execute
ESCAPE To Cancel
Figure 2-29. Confirmation Screen
As the confirmation screen indicates, to execute the load or unload, press the
Enter button. If the confirmation screen does not show your intended source
and destination, press the
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.A01 File Name: c-ch2 Operation Last Saved On: 3/1/99 2:14 PM
button to scroll line two to Slot 4. The screen
Enter button to select DLT0 as the destination.
at the end of line 4, nor
button to select DLT0. In
Enter
button to return to the 'From' entry screen.
Escape
Operation 2-23
at the end of line 1. There