Compaq TL891 - DLT Tape Library User Manual page 127

Running the Cleaning Cartridge
This procedure assumes that the cleaning cartridge has been installed into Slot
0 of the magazine.
1. At the Default Screen, press the Enter button. The screen shown in
Figure 5-1 appears:
Load/Unload
Show Status Menu
Maintenance Menu
Configure Menu
Figure 5-1. Main Menu
2. Press the
press the Enter button to select the Maintenance Menu. A screen similar
to Figure 5-2 appears:
Clean Drive
Diagnostic Menu
Demo Menu
Flash Update
Figure 5-2. Maintenance Submenu
3. Press the Enter button once to select Clean Drive. The screen shown in
Figure 5-3 appears:
Cleaning:
*DLT0
Using
*Slot0
Figure 5-3. Cleaning Submenu
4. Lines 2 and 4 are scrollable. The choices available on Line 2 are DLT0,
DLT1 and Both. Let us assume you want to clean DLT0. Press the
Enter button once to accept DLT0. The
display. Press the Enter button again to use the cartridge in Slot 0. (If
you cannot to use slot 0 for the cleaning cartridge, scroll to line 4 to
select another slot.)
5. The screen shown in Figure 5-4 appears:
Clean: DLT0
Use: Slot0
ENTER To Execute
ESCAPE To Cancel
Figure 5-4. Cleaning Confirmation Screen
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.AO1 File Name: f-ch5 Regular Maintenance Last Saved On: 3/1/99 2:15 PM
button twice to move the
Regular Maintenance 5-3
next to Maintenance, then
moves to line 4 of the