3. Center one of the support braces across the rear of the base section over
the holes on the rear surface of that section.
4. Insert two M4 x 20 Phillips sems screws through the holes in the support
brace into the holes in the base section, and tighten.
1
Figure 3-4. Pass-Through Mechanism Assembled
Support Brace
Motor Drive Section
Extension Section
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.A01 File Name: d-ch3 Installation Last Saved On: 3/2/99 2:30 PM
2
1
3
4
5
1
SHR-1236
Tie Bar
Base Section
Installation 3-9