Compaq TL891 - DLT Tape Library User Manual page 136

6-8 TL891 MiniLibrary System User's Guide
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.A01 File Name: g-ch6 Diagnostics and Troubleshooting Last Saved On: 3/3/99 11:54 AM
Table 6-2
Fault Symptom Codes
continued
FSC Message
1025 Overlapped Ctl Cmds
1026 Overlapped Ctl Msgs
1027 Control Process .
1028
Control Initializing
1030 Invalid SCSI ID
2001 Ctl Invalid Command
2002 Undefined Config
2003 Invalid Drive State
2004 Loader Not Ready
2005 SCSI Id Not Set
2006 DLT Comm Open Error
2007 Door Fault
Compaq Confidential – Need to Know Required
Description
The control process sent a command
while one was in process.
The control process sent a message
while one was in process.
The SCSI control process is busy
The SCSI control process is initializing.
The SCSI in NOVRAM is set to >= 8 an
the PWB is not configured for Wide
SCSI. Would only occur during SCSI
initialization.
Ctl. Invalid Command
An unsupported configuration was
detected.
One of the DLT drives was in an invalid
state This is caused by either
attempting to fetch a cartridge from an
empty drive, or stowing to a drive that
already has a cartridge loaded.
Currently not displayed.
An attempt to set the DLT SCSI id
failed.
An attempt to open a COM port failed.
An error occurred while attempting to
move the door.
continued