Compaq TL891 - DLT Tape Library User Manual page 183

Figure F-2. Removing the Skin Cover
Removing
Do these steps to remove the skin cover from the base module.
1. Loosen the two captive screws on the front panel until they are free of
the skin cover.
2. Remove the two screws on each side of the base module.
3. Slide the skin cover toward the rear of the module until it can be lifted
clear of the base module. Be careful that you don't dislodge the clip
nuts at the front of the skin cover.
Replacing
Do these steps to replace the skin cover on the base module.
1. Position the skin cover behind the base module with the two tabs with
clip nuts toward the front.
2. Slide the skin cover over the module until it touches the front panel.
3. Insert the two screws through the skin cover into the base module, but
don't tighten the screws yet.
4. Position the front edge of the skin cover so that it is flush against the
back of the front panel; tighten the captive screws in the clip nuts.
5. Tighten the two screws into the base module.
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibary System User's Guide Comments:
Part Number: ER-TL891-UA. A01 File Name: m-appf Addding a Second Tape Drive Last Saved On: 3/1/99 1:26 PM
Addding a Second Tape Drive F-3
SHR-1202
66