Compaq TL891 - DLT Tape Library User Manual page 42

2-18 TL891 MiniLibrary System User's Guide
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.A01 File Name: c-ch2 Operation Last Saved On: 3/1/99 2:14 PM
Drive Status Menu
When you select either of the drives, the menu shown in Figure 2-15 appears:
Tape Motion:
Idle
Tape Format:
No Tape
Figure 2-15. Drive Status Menu
This screen is scrollable. The list of Drive Status categories available is as
follows:
Map Information Screen
When you select Map Info, the screen shown in Figure 2-16 appears. The
location being reported appears on Line 1. The content of the bar code on the
label, up to 8 characters, appears on Line 4.
DLT0
Occupied
Label Valid
XXXXXXXX
Figure 2-16. Map Info Submenu
The list of locations available for display on line 1 is as follows. If you do not
designate any mail slots, those lines are omitted from the list.
Depending on the report for each location, Line 2 may display either 'Empty',
or 'Occupied', or, if a magazine is absent, 'Not Installed'.
Depending on the report for each location, Line 3 may display either 'Label
Valid', or 'Label Not Present'.
For each location reported, Line 4 will display the actual bar code on the label,
up to 8 characters.
Maintenance Menu
The Maintenance Menu and the options under it that are intended for operator
use are described in Chapter 5, Regular Maintenance.
Configure Menu
The Configure Menu, how to use it and the options available under it are
described in Chapter 3, Installation.
Compaq Confidential – Need to Know Required