Qos Wfq Group Sp - HP 6125XLG Command Reference Manual

qos wfq
•

qos wfq group sp

Use qos wfq group sp to assign a queue to the SP group.
Use undo qos wfq group sp to restore the default.
Syntax
qos wfq queue-id group sp
undo qos wfq queue-id
Default
When WFQ queuing is used on an interface, all the queues are in the WFQ group.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
queue-id: Specifies a queue by its ID in the range of 0 to 7.
sp: Assigns a queue to the SP group, which uses the SP queue scheduling algorithm.
Usage guidelines
This command is available only on a WFQ-enabled interface.
With the SP+WFQ queuing method, the system schedules first the queues in the SP group based on their
priorities and then the queues in WFQ groups. When scheduling WFQ groups, the system schedules first
the traffic conforming to the minimum guaranteed bandwidth of each queue in a WFQ group and then
the traffic beyond the minimum guaranteed bandwidths for the queues in the WFQ group according to
the configured weights. The two WFQ groups are scheduled at a 1:1 ratio.
You must use the qos wfq command to enable WFQ first before you configure this command.
The queue-id argument can be either a number or a keyword.
Examples
# Enable weight-based WFQ on interface Ten-GigabitEthernet 1/1/5, and assign queue 0 to the SP
group.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/5
[Sysname-Ten-GigabitEthernet1/1/5] qos wfq weight
[Sysname-Ten-GigabitEthernet1/1/5] qos wfq 0 group sp
Related commands
• display qos wfq interface
qos bandwidth queue
•
qos wfq
•
Table 32
84
shows the number-keyword map.