Configuring Sp+Wfq Queuing - HP 5830 Series Configuration Manual

Assign queue 0, queue 1, queue 2, and queue 3 on GigabitEthernet 1/0/1 to the SP queue
•
scheduling group.
Configure queue 4, queue 5, queue 6, and queue 7 on GigabitEthernet 1/0/1 to use WRR
•
queuing, with the weights 2, 4, 6, and 8, respectively.
The following is the configuration procedure:
# Enter system view.
<Sysname> system-view
# Enable the SP+WRR queue scheduling algorithm on GigabitEthernet1/0/1.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos wrr byte-count
[Sysname-GigabitEthernet1/0/1] qos wrr 0 group sp
[Sysname-GigabitEthernet1/0/1] qos wrr 1 group sp
[Sysname-GigabitEthernet1/0/1] qos wrr 2 group sp
[Sysname-GigabitEthernet1/0/1] qos wrr 3 group sp
[Sysname-GigabitEthernet1/0/1] qos wrr 4 group 1 byte-count 2
[Sysname-GigabitEthernet1/0/1] qos wrr 5 group 1 byte-count 4
[Sysname-GigabitEthernet1/0/1] qos wrr 6 group 1 byte-count 6
[Sysname-GigabitEthernet1/0/1] qos wrr 7 group 1 byte-count 8

Configuring SP+WFQ queuing

To guarantee successful WFQ configuration, make sure that the scheduling weight type (byte-count or
packet-based) is the same as the WFQ queuing type (byte-count) when you configure the scheduling
weight for a WFQ queue.
To configure SP + WFQ queuing:
Step
1. Enter system view.
2. Enter interface view.
3. Enable byte-count or
packet-based WFQ
queuing.
4. Assign a queue to the SP
queue scheduling group.
5. Assign a queue to the WFQ
queue scheduling group,
and configure a scheduling
weight for the queue.
6. Configure the minimum
guaranteed bandwidth for a
queue.
Command
system-view
interface interface-type
interface-number
qos wfq [ byte-count | weight ]
qos wfq queue-id group sp
qos wfq queue-id group 1
byte-count schedule-value
qos bandwidth queue queue-id
min bandwidth-value
46
Remarks
N/A
N/A
The default queuing algorithm on an
interface is SP queuing.
The weight keyword is not supported.
By default, all the queues of a
WFQ-enabled port use are in the WFQ
group.
Select weight or byte-count according to
the WFQ type (byte-count or
packet-based) you have enabled.
If you have enabled WFQ on the port,
the default scheduling weight is 1 for
each queue.
Optional.
64 kbps for each queue by default.