HP 6125XLG Command Reference Manual page 65

Parameters
name policy-name: Displays information about a QoS policy applied to VLANs. The policy-name
argument is a case-sensitive string of 1 to 31 characters.
vlan vlan-id: Displays information about the QoS policies applied to the VLAN specified by its ID.
inbound: Displays information about the QoS policy applied to the incoming traffic of the specified
VLAN.
outbound: Displays information about the QoS policy applied to the outgoing traffic of the specified
VLAN.
slot slot-number: Displays information about QoS policies applied to VLANs of the IRF member device
specified by the slot number.
Usage guidelines
If no direction is specified, this command displays information about QoS policies applied to VLANs in
both the inbound and outbound directions.
If no IRF member device is specified, this command displays information about all QoS policies applied
to VLANs of the device.
Examples
# Display information about QoS policies applied to VLAN 2.
<Sysname> display qos vlan-policy vlan 2
Vlan 2
Direction: Outbound
Policy: 1
Classifier: 1
Operator: AND
Rule(s) : If-match acl 2000
Behavior: 1
Marking:
Remark dscp 3
Committed Access Rate:
CIR 128 (kbps), CBS 8192 (Bytes), EBS 512 (Bytes)
Green action: pass
Yellow action: pass
Red action: discard
Green packets: 0(Packets)
Red packets: 0(Packets)
Classifier: 2
Operator: AND
Rule(s) : If-match protocol ipv6
Behavior: 2
Accounting enable:
0 (Packets)
Filter enable: Permit
Marking:
60