Error Messages - Oce TDS320 User Manual

Status Messages (continued)
Status messages Explanation
Sensor not free
Remove paper
Press <on-line>
Paper retracted
Press <on-line>
Copy too short
Remove paper
Press <on-line>
Inputflap open
Close inputflap
Inputflap open
Remove paper
Press <on-line>
Roll 1 empty
Open roll unit
Roll 2 empty
Open roll unit

Error messages

Error messages
Error messages
Copy too late
Remove paper
Press <on-line>
Speed failure
Remove paper
Press <on-line>
Knife 1 error
Remove paper
Press <on-line>
Knife 2 error
Remove paper
Press <on-line>
Roll retract err
Press <on-line>
34 Océ TDS320 User Manual
The paper of one of the rolls is transferred after the marker (see
'Feed the material' on page 113) when power is applied to the
printer.
Take the paper back.
Press <on-line>
Put the paper into the manual feed.
Press <on-line>
The length of the print material is less than 420 mm. This can oc-
cur with the manual feed.
Use an original longer than 420 mm.
The input flap is open.
Close the input flap.
The input flap is open during the print process
Remove the paper and press <on-line>.
The paper on roll 1 is empty.
Open the roll unit and replace it.
The paper on roll 2 is empty.
Open the roll unit and replace it.
Explanation
The copy is too late at the paperpath output sensor
Remove the print material.
A paper jam occurred.
Remove the paper jam and press <on-line>
An error occurred during the cut of the roll.
Check the paper in the roll unit and remove if necessary.
Press <on-line>.
An error occurred during the cut of the roll.
Check the paper in the roll unit and remove if necessary.
Press <on-line>.
Print material error when the roll unit takes back the material.