The Display - Oce TDS320 User Manual

The display

The display shows the feedback about the scan job status (see table below) in
normal mode. In off-line mode it shows the off-line menu (see page 58) and
(see page 66))
.
Status messages
Status Messages
Scanner ready
+
Connecting.....
Scanner asleep
Scanner running
Please wait
Remove original
Press <cancel>
Original too long
Press <cancel>
Wrong orig. type
Press <cancel>
Set closed
Reset scanner
40 Océ TDS320 User Manual
Explanation
The scanner is prepared to scan.
= add Add an original to the set and press the Start key
= close After the last scan of the set, remove the original and press
the Start key
There is no communication between the controller and the
scanner.
Wait until the there is communication.
The scanner is in low power mode.
The scanner scans.
The scanner downloads the languages.
There is an original on the table while you turn on the scan-
ner.
The message appears if you pressed the Cancel key while
you scan.
Remove the original.
Press cancel.
Use an original shorter than 15 meters.
This message shows when you select 'Background compen-
sation' and 'Blueprint' as original.
Press cancel.
You closed the copy set.
Turn the scanner on and off.
.
to close the set
.