Make A Scan - Oce TDS320 User Manual

Make a scan

To scan an original to file is an easy operation. If the settings (see 'Settings to
scan' on page 62) are correct, you must press the Start key
operator panel.
▼
How to make a scan
Place your original face-down, right aligned along the original guide.
1
Select the appropriate original type.
2
Press the Output key to select 'File'.
3
Select a Destination (see 'Destinations' on page 70).
4
Press the Start key
5
The original is scanned.
Select auto-feed on/off, rewind original on/off, and release paper
Note:
on/off in the 'scanner' menu on the scanner panel (see 'Menu structure Océ
TDS320 Scanner' on page 66). When release paper is enabled, the original
will be fully released after it is scanned.
On the controller, Océ View Station LT starts, to show the result of the scan
6
(see figure 15).
[15] Océ View Station
Use the Océ TDS320 to Scan to file
.
on the scanner
61