Displaying And Maintaining Mld Snooping - 3Com 4500G Family Configuration Manual

Configuring IPv6 multicast group replacement on a port or a group of ports
Follow these steps to configure IPv6 multicast group replacement on a port or a group of ports:
To do...
Enter system view
Enter Ethernet port/Layer 2
aggregate port view or port
group view
Enable IPv6 multicast group
replacement
Be sure to configure the maximum number of IPv6 multicast groups allowed on a port (refer to
Configuring Maximum Multicast Groups that Can Be Joined on a
group replacement. Otherwise, the IPv6 multicast group replacement functionality will not take effect.

Displaying and Maintaining MLD Snooping

To do...
View MLD Snooping multicast group
information
View the statistics information of
MLD messages learned by MLD
Snooping
Clear MLD Snooping multicast group
information
Clear the statistics information of all
kinds of MLD messages learned by
MLD Snooping
The reset mld-snooping group command works on an MLD Snooping–enabled VLAN.
The reset mld-snooping group command cannot clear the MLD Snooping multicast group
information for static joining.
Use the command...
system-view
interface interface-type
interface-number
port-group manual
port-group-name
mld-snooping overflow-replace
[ vlan vlan-list ]
Use the command...
display mld-snooping group [ vlan
vlan-id ] [ verbose ]
display mld-snooping statistics
reset mld-snooping group
{ ipv6-group-address | all } [ vlan
vlan-id ]
reset mld-snooping statistics
1-18
Remarks
—
Required
Use either approach
Required
Disabled by default
Port) before enabling IPv6 multicast
Remarks
Available in any
view
Available in any
view
Available in user
view
Available in user
view