Configuring Attributes Related To Data To Be Sent To The Radius Server - 3Com 4500G Family Configuration Manual

To do...
Set the status of the secondary
RADIUS accounting server
The server status set by the state command cannot be saved in the configuration file and will be
restored to active every time the server restarts.

Configuring Attributes Related to Data to Be Sent to the RADIUS Server

Follow these steps to configure the attributes related to data to be sent to the RADIUS server:
To do...
Enter system view
Enable the RADIUS trap
function
Create a RADIUS scheme and
enter RADIUS scheme view
Specify the format of the
username to be sent to a
RADIUS server
Specify the unit for data flows or
packets to be sent to a RADIUS
server
Set the
source IP
address of the
device to
send RADIUS
packets
state secondary accounting
{ active | block }
system-view
radius trap
{ accounting-server-down |
authentication-server-down }
radius scheme
radius-scheme-name
user-name-format
{ keep-original
without-domain }
data-flow-format { data { byte
| giga-byte | kilo-byte |
mega-byte } | packet
{ giga-packet | kilo-packet |
mega-packet | one-packet } }*
In RADIUS
nas-ip ip-address
scheme view
quit
In system view
radius nas-ip ip-address
Use the command...
Use the command...
with-domain |
|
1-27
Remarks
Remarks
—
Optional
Disabled by default
Required
Not defined by default
Optional
By default, the ISP domain
name is included in the
username.
Optional
The defaults are as follows:
byte for data flows, and
one-packet for data packets.
Use either command
By default, the outbound port
serves as the source IP
address to send RADIUS
packets