Filtering Ipv6 Packets - 3Com 4500G Family Configuration Manual

To do...
Exit to system view
Configure the interval for
collecting and outputting IPv4
packet filtering logs
The packet filtering statistics are managed and output as device log information by the information
center.
The packet filtering statistics are of the severity level of 6, that is, informational. Informational
messages are not output to the console by default; therefore, you need to modify the log
information output rule for the informational message output to be sent to the console or other
destinations.
For introduction and configuration of the information center, refer to Information Center
Configuration in the System Volume.

Filtering IPv6 Packets

Follow these steps to apply an IPv6 ACL to an interface to filter IPv6 packets:
To do...
Enter system view
Enter
interface
view
Apply a basic or advanced IPv6
ACL to the interface to filter
IPv6 packets
Exit to system view
Configure the interval for
collecting and outputting IPv6
packet filtering logs
quit
acl logging frequence
frequence
system-view
Enter Ethernet
interface interface-type
interface view interface-number
Enter VLAN interface vlan-interface
interface view vlan-id
packet-filter ipv6
{ acl6-number | name
acl6-name } inbound
quit
acl ipv6 logging frequence
frequence
Use the command...
Use the command...
4-2
Remarks
—
Required
By default, the interval is 0, that
is, no IPv4 packet filtering logs
are output.
Remarks
—
Use either command
Required
By default, no IPv6 ACL is
applied to the interface.
—
Required
By default, the interval is 0, that
is, no IPv6 packet filtering logs
are output.