Comprehensive Selective Qinq Configuration Example - 3Com 4500G Family Configuration Manual

Comprehensive Selective QinQ Configuration Example

Network requirements
Provider A and Provider B are edge devices on the service provider network and are
interconnected through trunk ports. They belong to SVLAN 1000 and SVLAN 2000 separately.
Customer A, Customer B and Customer C are edge devices on the customer network.
Third-party devices with a TPID value of 0x8200 are deployed between Provider A and Provider B.
Make configuration to achieve the following:
VLAN 10 frames of Customer A and Customer B can be forwarded to each other across SVLAN
1000;
VLAN 20 frames of Customer A and Customer C can be forwarded to each other across SVLAN
2000.
Figure 1-5 Network diagram for comprehensive selective QinQ configuration
Customer A
VLAN 10, 20
Provider A
GE1/0/1
GE1/0/3
GE1/0/2
Customer B
VLAN 10
Configuration procedure
Make sure that the devices in the service provider network have been configured to allow QinQ packets
to pass through.
1) Configuration on Provider A
Configure GigabitEthernet 1/0/1
# Configure GigabitEthernet 1/0/1 as a hybrid port to permit frames of VLAN 1000 and VLAN 2000 to
pass through, and configure GigabitEthernet 1/0/1 to send packets of these VLANs with tags removed.
<ProviderA> system-view
[ProviderA] interface gigabitethernet 1/0/1
[ProviderA-GigabitEthernet1/0/1] port link-type hybrid
[ProviderA-GigabitEthernet1/0/1] port hybrid vlan 1000 2000 untagged
GE1/0/1
VLAN 1000, 2000
TPID = 0x8200
GE1/0/2
Public network
Customer C
VLAN 20
1-9
Provider B