Establishing An Ftp Connection; Configuring The Ftp Client - 3Com 4500G Family Configuration Manual

If no primary IP address is configured on the specified source interface, no FTP connection can be
established.
If you use the ftp client source command to first configure the source interface and then the
source IP address of the transmitted packets, the newly configured source IP address will take
effect instead of the current source interface, and vice versa.
Follow these steps to establish an FTP connection (In IPv6 networking):
To do...
Log in to the remote FTP server
directly in user view
Log in to the remote FTP server
indirectly in FTP client view

Configuring the FTP Client

After a device serving as the FTP client has established a connection with the FTP server (For how to
establish an FTP connection, refer to
operations in the authorized directories of the FTP server:
To do...
Display help information of
FTP-related commands
supported by the remote FTP
server
Enable information display in a
detailed manner
Enable FTP related debugging
when the device acts as the
FTP client
Use another username to relog
after logging in to the FTP
server successfully
Set the file transfer mode to
ASCII
Set the file transfer mode to
binary
Change the working path on
the remote FTP server
Use the command...
ftp ipv6 [ server-address
[ service-port ] [ source ipv6
source-ipv6-address ] [ -i
interface-type
interface-number ] ]
ftp ipv6
open ipv6 server-address
[ service-port ] [ -i interface-type
interface-number ]
Establishing an FTP
Use the command...
remotehelp
[ protocol-command ]
verbose
debugging
user username [ password ]
ascii
binary
cd { directory | .. | / }
2-4
Remarks
Use either approach.
The ftp ipv6 command is
available in user view; and the
open ipv6 command is
available in FTP client view.
Connection.), you can perform the following
Remarks
Optional
Optional
Enabled by default
Optional
Disabled by default
Optional
Optional
ASCII by default
Optional
ASCII by default
Optional