Displaying And Maintaining Http; Http Configuration Example - 3Com 4500G Family Configuration Manual

Displaying and Maintaining HTTP

Display information about HTTP

HTTP Configuration Example

Network requirements
As shown in Figure
addresses, implementing that only users in the 10.1.1.0/24 segment can access and control the device
through the Web interface.
Figure 1-1 HTTP network diagram
Device
10.1.1.1/24
10.1.1.2/24
Host A
Configuration procedure
1) Configure the HTTP server Device.
# Create a basic ACL 2000, allowing packets with the source IP address in 10.1.1.0/24.
<Device> system-view
[Device] acl number 2000
[Device-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Device-acl-basic-2000] quit
# Associate the HTTP service to ACL 2000.
[Device] ip http acl 2000
# Enable the HTTP service.
[Device] ip http enable
2) Verify the configuration.
If you open the IE on Host A, and type http://10.1.1.1, you can open the Web login page of Device.
If you open the IE on Host B, and type http://10.2.1.1, you cannot open the Web login page of Device.
To do...
1-1, filter users logging in through Web interface according to the source IP
10.2.1.1/24
10.2.1.2/24
Host B
Use the command...
display ip http
1-3
Remarks
Available in any view