Bang & Olufsen BeoVision 7 Reference Book page 45

Calibrate the sound level
When you have connected speakers in a
surround sound setup to the television, you
must perform a speaker calibration.
A calibration sound is produced alternately in
each of the speakers you have connected in
your surround sound setup. Your task is to
adjust the sound level from all the connected
speakers to match the sound level from the
centre speaker. You can choose whether you
want the sound sequence to occur
automatically or manually.
Once you have performed your speaker
calibration, you will only need to re-calibrate
the speaker sound if you make changes to the
setup, for example, if you move one or more
of the speakers.
SPEAKER LEVEL
SEQUENCE AUTOMATIC
LEFT FRONT . . . . . . . .
RIGHT FRONT . . . . . . . .
RIGHT REAR . . . . . . . .
LEFT REAR . . . . . . . .
store
It is not necessary to calibrate subwoofer sound in
a surround sound setup. If you still wish to adjust
subwoofer sound when your speaker calibration is
complete, refer to the section 'Sound adjustments'
on page 46.
> Press MENU to bring up the TV SETUP menu
and press
> Press GO to bring up the OPTIONS menu and
press to highlight SOUND.
> Press GO to bring up the SOUND SETUP menu
and press
> Press GO to bring up the SPEAKER LEVEL menu.
SEQUENCE is highlighted.
GO
> Press or
and MANUAL.
> Press or
or to move to another speaker.
> When you have adjusted the sound for all the
speakers in your surround sound setup, press
GO to store or press EXIT to leave the menu
without storing.
To make settings for Home cinema ...
> Press LIST until FORMAT is shown in the Beo4
display, then press 0 to activate your Home
cinema setup.
> Repeat the procedure above and enter the
appropriate speaker distances from your Home
cinema viewing position.
to highlight OPTIONS.
to highlight SPEAKER LEVEL.
to choose between AUTOMATIC
to adjust the speaker sound and
45