Bang & Olufsen BeoVision 7 Reference Book page 39

Connect a projector
> Connect a low-power IR transmitter to one of
the IR CONTROL OUT sockets (C1–C4) on the
rear of the television and mount it near the IR
receiver on the projector; enabling Beo4 remote
control operation of the projector.
> Connect the projector to the PROJECTOR socket
of the television.
> Complete your projector setup.
If necessary, connect an IR receiver to the IR IN
socket on the television, and mount the IR receiver
as explained in the instructions enclosed with the
receiver.
For further information about the placement of
sockets, refer to the chapter 'Socket panels' on
page 32.
PROJECTOR
TYPE SELECT
IR SOCKET C4
store
> Press TV to switch on the television.
> Press MENU to bring up the TV SETUP menu
and press to highlight OPTIONS.
> Press GO to bring up the OPTIONS menu.
CONNECTIONS is highlighted already.
> Press GO to bring up the CONNECTIONS menu.
> Press to move to the PROJECTOR and press
GO to bring up the PROJECTOR menu.
> Press to switch between the settings. To be
able to select a projector type, set the field to
'SELECT'.
> Press to move to IR SOCKET and press
select the IR socket used for the projector.
> Press GO to store your setup, or ...
> ... press EXIT to exit the menu without storing.
> When you have set the 'TYPE' to 'SELECT' you
will be prompted to select your projector from
an on-screen list.
Switch to Home cinema ...
Press repeatedly to display
FORMAT on Beo4
Press to switch between Home
cinema mode and ordinary TV
mode
Press to leave the format
function
GO
or to
39
LIST
FORMAT
0
EXIT