Bang & Olufsen BeoVision 7 Reference Book page 34

34
This chapter describes how to
connect additional video equipment
to the television.
A decoder can be connected to the
television via the AV sockets. If your
setup also includes a Bang & Olufsen
video recorder, you should connect
the decoder to the video recorder.
A set-top box can be connected to
any of the AV sockets.
When you connect a Bang & Olufsen
video recorder, you must connect it
to the AV1 socket, the television
detects the connection automatically.
Make sure that all connected
equipment is registered in the
CONNECTIONS menu. For further
information, refer to the chapter
'Register additional video equipment'
on page 40.
Connect additional video equipment
Connect a decoder
Decoder
Disconnect all involved systems from the mains
before you connect external equipment.
> Connect the cable from the external aerial to
the socket marked TV IN on the television.
> Connect the decoder to one of the 21-pin AV
sockets on the television.
If you wish to connect an RF decoder, remember
to connect the external aerial cable to the decoder
input socket and then forward the signal or cable
to the television's aerial socket (marked 'TV IN').
BeoVision
Tuned programs and decoder detection
In most cases, a connected decoder is registered
automatically during tuning. The decoder should
automatically detect those programs which require
decoding. However, if this is not the case, then
adjust the setting via the MANUAL TUNING menu
for the program in question. Please refer to the sub-
section entitled 'Adjust tuned TV programs' in the
chapter 'Edit tuned TV programs' on page 19.