Bang & Olufsen BeoVision 7 Reference Book page 30

30
>> Set up your television
Aerial and mains connections
When all connections are complete, switch
on the mains. A tiny, red light appears at the
bottom of the right hand side of the screen.
The system is in standby mode and ready to
be used. If your television is set up on its own,
you can now tune in programs as explained
in the chapter 'First-time setup of your
television' on page 14.
Your television was designed to be left in
standby mode when not in use. Therefore, to
facilitate remote control operation, it is
essential that you do not disconnect it from
the mains.
The television can only be switched off
completely by disconnecting it from the wall
socket.
Avoid bending, twisting or subjecting the aerial
cable to pressure or impact.
BeoLab
The supplied mains cord and plug are specially
designed for the television. If you change the plug
or in any way damage the mains cord, it will affect
the TV picture adversely!
We suggest that you lead the cables through the
flexible cable cover before connecting them to the
sockets.
Leave enough slack in the cable to ensure that the
TV is able to tilt and turn if required – Test that the
loops are big enough before using the cable tiers
and mounting the cable covers.
BeoVision