Bang & Olufsen BeoVision 7 Reference Book page 37

Connect a set-top box to a Bang &
Olufsen recorder
Disconnect all involved systems from the
mains before you connect external
equipment.
> Connect one end of a 21-pin AV cable to the
set-top box.
> Run the cable to the DECODER or AUX socket
on the back of Bang & Olufsen recorder.
> Use another 21-pin AV cable to connect the
video recorder to the AV1 socket on your
television.
> Connect the IR transmitter to one of the IR
OUTPUT sockets on the television.
> Fasten the IR transmitter to the IR receiver of
the set-top box.
Note: Only BeoCord V 8000 with software version
3.1 or higher can be connected this way. Please
contact your retailer, if you require further
information.
You must connect your set-top box to the video
recorder to be able to record set-top box
programs.
While recording from the set-top box, you cannot
watch a different set-top box program at the
same time.
Set-top box
Video recorder
Automatic standby ...
When you register a set-top box in the
CONNECTIONS menu, you can also select an
'AUTO STANDBY' time for your set-top box. This
means that you can select if the connected set-
top box should switch to standby automatically.
BeoVision
The options are:
AFTER 0 MIN ... The set-top box switches to
standby immediately when you select another
source.
AFTER 30 MIN ... The set-top box switches to
standby 30 minutes after you have selected
another source*.
AT TV STANDBY ... The set-top box switches to
standby when you switch the television to
standby.
NEVER ... The set-top box does not switch to
standby automatically.
FOLLOW TV ... The set-top box switches on,
when you switch your television on and it
switches to standby, when you switch your
television to standby.
*If you switch the television to standby before the
30 minutes have passed, the set-top box also
switches to standby.
37