Color Density Adjustment; Adjustment Recovery; Exiting The Menu - Xerox phaser 2135 Advanced Features And Troubleshooting Manual

Color Density Adjustment

1. Identify the square where the bar and background patterns blend together. If this
square is the Current (0) square, no adjustment is needed. Continue to Exiting the
Menu.
2. Press Item Up or Item Down (labeled 2 and 6) until you see:
3. Press Value Up or Value Down (labeled 3 and 7) until he Value is equal to the number
of the square identified in step 1:
4. Press Enter (labeled 4). The Color Adjust Page prints showing you the changes that
resulted from the previous steps and the front panel displays:
5. Repeat Steps 3 and 4 above until the bar and background patterns in the Current (0)
square blend together.

Adjustment Recovery

While in the color adjustment routine you can choose to return the values to the factory
default values by using the Color Adjust menu's Color Defaults item.
The printer will be restored to the factory default values.

Exiting the Menu

Using the item keys (labeled 2 and 6), scroll to "Exit and Accept Changes", use the Value
Keys (labeled 3 and 7) to scroll to Yes. If you press the On-line Key or a Menu key (labeled
1 or 5), while you are in the Color Adjust menu, you automatically go to this Menu item.
You must then use the Value keys (labeled 3 and 7) to scroll to "Yes" and press the Enter
(labeled 4) key to save and exit.
Note
Once you have made an adjustment, you cannot undo the changes. You can
return the values to the factory defaults.
Advanced Features and Troubleshooting Manual
Adjusting Color Density and Balance
Color Adjust Menu
Color Density
Color Density =
New Value
Color Adjust Menu
Color Density
75