Installing And Removing An Optional Mezzanine Board - Gateway E-9425R User Manual

CHAPTER 4: Installing Components

Installing and removing an optional mezzanine board

56
Slide the ROMB battery pack for the mezzanine RAID card (2) toward the
5
front of the chassis until it clicks into place.
Follow the instructions in
6
This server has two types of optional mezzanine boards. They include a
2-channel SAS mezzanine board, and 2-channel SAS mezzanine board with
RAID. They are designed to provide extra HDD storage capability with one
160-pin mezzanine board connector. Each type of mezzanine board uses the
specific chipset for optimal features and provides expansive storage by
connecting with the extra drives.
To install an optional mezzanine board:
Follow the instructions in
1
page 30. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
Follow the instructions in
2
Remove the PCI riser assembly by following the instructions in
3
and removing PCI expansion cards" on page
Align the holes on one side of the board with the plastic standoffs (1) and
4
align the other side with the mezzanine board slot.
Push down on the board (2) to seat it in the mezzanine board slot and onto
5
the plastic standoffs until the retaining tabs snap into place.
Replace the PCI riser card assembly by following the instructions in
6
"Installing and removing PCI expansion cards" on page 43.
Follow the instructions in
7
"Closing the server case" on page
"Preventing static electricity discharge" on
"Opening the server case" on page
43.
"Closing the server case" on page
www.gateway.com
32.
31.
"Installing
32.