Wpa-Psk/Wpa2-Psk - ZyXEL Communications NBG-419N User Manual

11.4.3 WPA-PSK/WPA2-PSK

Click Network > Wireless LAN to display the General screen. Select WPA-PSK or WPA2-PSK
from the Security Mode list.
Figure 71 Network > Wireless LAN > General: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
Table 40 Network > Wireless LAN > General: WPA-PSK/WPA2-PSK
LABEL
Security Mode
WPA-PSK
Compatible
Pre-Shared Key
Group Key
Update Timer
Apply
Reset
Refer to Table 37 on page 88
NBG-419N User's Guide
DESCRIPTION
Select WPA-PSK or WPA2-PSK to enable data encryption.
This field appears when you choose WPA-PSK2 as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to
connect to your NBG-419N.
WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
The Group Key Update Timer is the rate at which the AP sends a new group
key out to all clients.
The default is 3600 seconds (60 minutes).
Click Apply to save your changes back to the NBG-419N.
Click Reset to reload the previous configuration for this screen.
for descriptions of the other labels in this screen.
Chapter 11 Wireless LAN
93