ZyXEL Communications NBG-419N User Manual page 49

Note: You can enable the Wireless function of your NBG-419N by first turning on the
switch in the back panel.
Figure 37 Wireless Security
The following table describes the general wireless LAN labels in this screen.
Table 22 Wireless Security
LABEL
Wireless
Network Name
(SSID)
Security mode
Wireless
password
Verify
password
Apply
Cancel
WPS
NBG-419N User's Guide
DESCRIPTION
(Service Set IDentity) The SSID identifies the Service Set with which a wireless
station is associated. Wireless stations associating to the access point (AP) must
have the same SSID. Enter a descriptive name (up to 32 keyboard characters) for
the wireless LAN.
The default SSID is NBG-419N.
Select WPA-PSK or WPA2-PSK to add security on this wireless network. The
wireless clients which want to associate to this network must have same wireless
security settings as this device. After you select to use a security, additional options
appears in this screen.
Select No Security to allow any client to connect to this network without
authentication.
This field appears when you choose wither WPA-PSK or WPA2-PSK as the
security mode.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Type the password again to confirm.
Click Apply to save your changes back to the NBG-419N.
Click Cancel to close this screen.
Click this to configure the WPS screen.
You can transfer the wireless settings configured here (Wireless Security screen)
to another wireless device that supports WPS.
Chapter 6 Easy Mode
49