Setting Your Nbg-419N To Wisp Mode; Accessing The Web Configurator In Wisp Mode - ZyXEL Communications NBG-419N User Manual

9.3.1 Setting your NBG-419N to WISP Mode

Log into the Web Configurator if you haven't already. See the Quick start Guide for instructions on
1
how to do this.
To set your NBG-419N to AP Mode, go to Maintenance > Sys OP Mode > General and select
2
WISP Mode.
Figure 50 Changing to WISP mode
Note: You have to log in to the Web Configurator again when you change modes.As soon
as you do, your NBG-419N is already in WISP mode.
When you select WISP Mode, the following pop-up message window appears.
3
Figure 51 Pop up window for WISP mode
Click OK. The Web Configurator refreshes once the change to WISP mode is successful.

9.3.2 Accessing the Web Configurator in WISP Mode

To login to Web Configurator in WISP mode, do the following:
Connect your computer to the LAN port of the NBG-419N.
1
The default IP address of the NBG-419N is "192.168.1.1". If you did not change this, you can use
2
the same IP address in WISP mode. Open a web browser such as Internet Explorer and type
"192.168.1.1" as the web address in your web browser.
If you changed the IP address of your NBG-419N while in Router Mode, use this IP address in WISP
mode. The WISP mode IP address is always the same as the Router mode IP adderss.
NBG-419N User's Guide
Chapter 9 WISP Mode
67