Wpa-Psk/Wpa2-Psk - ZyXEL Communications ARMOR Z1 NBG6816 User Manual

The following table describes the labels in this screen.
Table 29 Expert > Wireless > Security Mode: No Security
LABEL
Security Mode
Apply
Cancel

11.3.2 WPA-PSK/WPA2-PSK

Select WPA-PSK or WPA2-PSK from the Security Mode list.
Note: WPA-PSK is not available if you enable WPS before you configure WPA-PSK in the
Expert > Wireless > Wireless screen.
Figure 56 Expert > Wireless > Security Mode: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
Table 30 Expert > Wireless > Security Mode: WPA-PSK/WPA2-PSK
LABEL
Security Mode
WPA-PSK
Compatible
Pre-Shared Key
Chapter 11 Wireless LAN
DESCRIPTION
Choose No Security from the drop-down list box.
Click Apply to save your changes back to the ARMOR Z1.
Click Cancel to reload the previous configuration for this screen.
DESCRIPTION
Select WPA-PSK or WPA2-PSK to enable data encryption.
This field appears when you choose WPA2-PSK as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to connect to
your ARMOR Z1.
WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
ARMOR Z1 User's Guide
91