Enabling And Configuring Wireless Security (No Wps) - ZyXEL Communications NBG-419N User Manual

10.4 Enabling and Configuring Wireless Security (No WPS)

This example shows you how to configure wireless security settings with the following parameters
on your NBG-419N.
SSID
Channel
Security
Follow the steps below to configure the wireless settings on your NBG-419N.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see
Open the Wireless LAN > General screen in the AP's Web Configurator.
1
Make sure the Enable Wireless LAN check box is selected.
2
Enter SSID_Example3 as the SSID and select a channel.
3
Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared
4
Key field. Click Apply.
Figure 61 Tutorial: Network > Wireless LAN > General
NBG-419N User's Guide
SSID_Example3
6
WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
Chapter 10 Tutorials
Section 3.2 on page 29).
79