Xpndr Field; Lfreq Field - Motorola DSR-6100 Operator's Manual

Motorola dsr-6100 commercial integrated receiver transcoder

Hide thumbs Also See for DSR-6100:

Table of Contents

Xpndr Field

This field is not available when Input field is set to either ASI In or GigE In. This

field is not available when the Mode field is set to LFreq.

This field allows selection of an initial satellite transponder number and can only

be used if the Xpndr option in the Mode field is selected. The Xpndr field cannot be

edited if L Freq in the Mode field is selected. Press the 4 button until the cursor is

at the Xpndr label. Then press the ENTER button to move into the field.

Then press the  buttons to select the desired transponder number. Since the

associated transponder/frequency tables are stored in the DSR-6100, scroll through

the transponder numbers and notice that the associated frequency (shown in the

LFreq field to the right) automatically changed with the selection (970-1430 MHz).

There are 24 transponder options, and when the desired transponder selection is

displayed, press the ENTER button to confirm selection and move the cursor back

up to the field label.

This field is not available when Input field is set to either ASI In or GigE In. If the

Mode field is set to Xpndr, this field is set automatically and cannot be edited.

If the LFreq option in the Mode field is chosen, use this field, to directly tune the

frequency. Press the 4 button until the cursor is at the LFreq label. Then press the

ENTER button to move into the field.

Use the arrow buttons ( 4  ) to select the desired frequency. Select a

frequency between 950 MHz and 2150 MHz and press the ENTER button to

confirm the selection and move the cursor back up to the field label.

For those satellite carriers which are offset (C-band or Ku-Band), use the L Freq

option to enter the exact center frequency of a carrier, rather than using a nearby-

but-not-exact C-band transponder center frequency. Long-term frequency tracking

is best if the user enters a precise carrier center frequency.

Contact the programmer or network operator for details about the satellite, transpon-

der, and frequencies being used. If one frequency is identified as the root transponder,

using this frequency may expedite the download process during installation.

Table of Contents

Show Quick Links

Table of Contents