Table of Contents
Advertisement
Pan sensor
Each zone has a sensor on it, so it can detect the presence of a pan.
o The sensor is fine-tuned to detect a pan being placed on it. The
pan should be one size smaller than the nominal diameter of the
zone.
o If after placing a pan on a cooking zone and
Or it could be made from a material that is inappropriate for use
on an induction zone hob.
o If a cooking zone is selected but no pan is detected, the pan
sensor
system
approximately every few seconds. If no pan is detected after 2.5
seconds the hob will automatically switch off
o You should check that your pans are suitable for use on an
induction zone hob (see the pan manufacturer's trademark or
instructions).
Cookware that is suitable for an induction hob
The table below shows cookware that is normally suitable for use on
an induction zone hob:-
Cookware
Steel, enamelled steel
Cast iron
Stainless steel
Aluminium, copper, brass
Glass, induction, porcelain
o The bottom of the pans should be as flat and thick as possible.
o Certain types of cookware may result in a noise being made
when being used on an induction zone hob. This does not mean
that there is an appliance fault.
o IMPORTANT: You should make sure that all pans are placed in
the centre of the induction zone that you are using.
selecting that cooking zone, a "U" shaped symbol
appears on the cooking zone indicator, this means
that the pan is either the incorrect size or shape.
will
check
for
Suitable
Yes
Yes
Yes
manufacturer)
No
No
17
the
presence
of
(if
stated
by
a
pan
the
pan
Advertisement
Table of Contents
