Automatic Ignition With Flame Failure Device - Baumatic BHI909TS. GWK Instruction Manual

Automatic ignition with flam
The wok burner is fitted with a flame failure safety device, which is
designed to stop the flow of gas to the burner head in the event of the
flame going out.
To ignite a burner:
o Press in the control knob of the burner and turn it to the ignition
position.
o If you keep the control knob depressed, the automatic ignition
for the burner will operate.
o You should hold down the control knob for 20 seconds after the
flame on the burner has lit.
o After this 20 second interval, to regulate the flame you should
continue turning the control knob until the flame is at a suitable
level. The operating position MUST be at a position between the
maximum and minimum position.
o To switch the burner off, turn the control knob fully to the gas off
position.
o In case of power failure, the burner can be lit by carefully using
a match.
e failure safety device
24