Control Panel Buttons - Xerox DocuColor 12 User Manual

Control Panel Buttons

The function of the Control Panel hard buttons is
described below. The numbers before the
descriptions correspond to the numbered call-outs
in Figure 3.
1 Numeric Keypad - Buttons 0 to 9 are used to
select a copy quantity up to the value set in the
Tools mode. These buttons are also used to enter
an access number.
2 Administration - This button is used by the
System Administrator.
3 Access - The copier/printer can be activated in
either the normal copying mode (without an
access number) or in the Access Number mode.
If the copier/printer is in the Access Number
mode, use the Access button to bring up the
Access screen and enter your access number
before trying to make any copies. Press the
Access button after you complete your job to exit
the user screens and ensure that no one else can
make copies using your access number.
4 Low Power button - Press this button to initiate
the Low Power mode. The DocuColor 12 will also
go into Low Power mode automatically if it is not
used for a length of time specified by the System
Administrator in the Tools Mode.
The Low Power mode enables the DocuColor 12
to use less power than when it is in Ready mode.
Press the Low Power button again to bring the
copier/printer into a warm-up cycle.
DOCUCOLOR 12 USER GUIDE
2
1
Figure 3: Control Panel buttons
2–3 GETTING TO KNOW YOUR DOCUCOLOR 12
3
4
6
5
7
8
1
2
3
4
5
6
7