Interrupting A Copy Job; To Interrupt Copying - Konica Minolta DI2510 Advanced Information

5
5.3

Interrupting a Copy Job

The current copy job can be paused so that a copy of a different document
can be made.
This is convenient if you wish to quickly make copies of a short document
while a large job is being printed.
Note
If certain functions are specified, it may not be possible to interrupt the
copy job. In addition, some functions are not available while a copy job
is interrupted.
The copier will not enter Interrupt mode (pause copying by pressing
the [Interrupt] key) while a document is being scanned.
For details, refer to the "Function Combination Table" on page 14-11.

To interrupt copying

1
Press the [Interrupt] key while a job
is being printed.
H
The indicator on the [Interrupt]
key lights up.
H The message "Now in the interrupt mode." appears.
H The copy settings return to their defaults.
(The copy settings of the job before the interruption and the
remaining number of copies are recorded.)
H If no operation is performed for one minute after the [Interrupt] key
is pressed, the Interrupt mode is automatically cancelled.
2
Position the document(s) to be copied.
3
Select the desired copy settings.
4
Press the [Start] key.
H Scanning of the document begins.
5
When the interrupt mode copy has completed, press the [Interrupt]
key.
The indicator on the [Interrupt] key goes off and the Interrupt mode is
cancelled.
The copy settings for the job before copying was interrupted appear,
and copying of the job that was interrupted automatically continues.
5-4
Basic Copy Operations
Di2510/Di3010/Di3510