Displaying, Editing Regional Operating Area Status - Furuno UAIS TRANPONDER FA-150 Operator's Manual

1.9.2

Displaying, editing regional operating area status

You may display the status of regional operating areas currently memorized in
the equipment. Nine of any combination of AIS message from shore-based AIS,
DSC message, manual settings and commands from ECDIS or a PC may be
registered and one will be HIGH SEA.
About registering areas
• AIS and DSC messages registered within last two hours cannot be edited.
• An item labeled HIGH SEA cannot be registered. ("HIGH SEA" are data used
for international waters not controlled by shore-based AIS.)
• If two areas overlap one another the older data is deleted.
• Data older than five weeks is deleted.
• Area data is deleted when it is more than 500 miles from the area for which it
was registered.
1. Press the MENU key to open the menu.
2. Select CHANNEL SETTINGS then press the ENT key.
3. Select EDIT CHANNEL then press the ENT key.
SELECT NO.: File number, 0-9. In order of distance from own ship,
TIME:
MMSI:
TYPE:
Note: MMSI and TYPE must be set to other than "HIGH SEA" to edit.
4. Select desired file number from SELECT NO.
[EDIT CHANNEL]
SELECT NO. : 0
TIME [UTC]
- -/- - - - -: - -: - -
FROM
MMSI: - - - - - - - - -
TYPE: MANUAL
QUIT [MENU] EDIT[ENT]
from closest to furthest.
Data and time equipment controlled by external source.
MMSI displayed for control by DSC or shore-based AIS.
Dashes or "EMPTY" (no data) otherwise.
How channel is controlled: AIS, AIS message; HIGH SEA
(for reference setting), PI, ECDIS or PC; DSC, DSC;
MANUAL, manual control
1. OPERATION
1-31