Furuno UAIS TRANPONDER FA-150 Operator's Manual page 44

20. LON of RIGHT TOP is selected; press the ENT key. Enter longitude for the
right-top position (northeast point) of the AIS operating area then press the
ENT key.
21. LAT of LEFT BOTTOM is selected; press the ENT key. Enter latitude for the
left-bottom position (southwest point) of the AIS operating area then press
the ENT key.
22. LON of LEFT BOTTOM is selected; press the ENT key. Enter longitude for
the left-bottom position (southeast point) of the AIS operating area then
press the ENT key.
Note: The available range is 20-200 nm. If the area contains overlapping
data the older data will be erased.
LEFT-BOTTOM
23. Press the MENU key. The prompt shown below appears.
24. Press ◄ to select YES then press the ENT key.
Note: If a combination other than that shown in the table at step 13 is
selected, the message "ILLEGAL MODE WAS SELECTED PRESS ANY
KEY." appears.
25. Press the DISP key to close the menu.
Note: If you enter invalid data, the message "OUT OF RANGE!: OO" appears.
Press any key to escape. Reenter data.
20-200 nm
RIGHT-TOP
ZONE
1-8 nm
SAVE CHANNEL.
ARE YOU SURE?
YES NO
1. OPERATION
1-33